Komodo CERAMIC LAMP FIXTURE
Thursday, February 4th, 2010Komodo products are made by Underworld one of the biggest suppliers and manufacturers in the UK. Their Komodo Ceramic Light Fitting is heat resistant and designed with the reptile keeper in mind. The Ceramic light fitting is an Edison screw type NOT bayonet and so will take most makes of reptile bulbs and ceramic heat emitters. It comes with a good length of power cable, an inline manual on/off switch and fitted 3 pin plug. Fixing the fitting into a wooden vivarium could not be easier, I use a screw in hook screwed into the inside top of the vivarium and loop the cable in place then secure it with a tie wrap to stop it from slipping. Fixing a heater or bulb guard is easily slipped over the Ceramic fitting and screwed in place.
Can be used with the following lamps and heat emitters all of which can be supplied by ValueAquatics
Arcadia D3 Compact Reptile Lamp 23w
Exo Terra Solar Glo Sun Lamp 125w & 160w
Exo Terra Sun Glo Neodymium Daylight Lamp 15w to 100w
Exo Terra Night Glo Moonlight Lamp 15w to 150w
Exo Terra Sun Glo Neodymium Daylight Basking Spot Lamp 50w to150w
Exo Terra Sun Glo Tight Beam Basking Spot Lamp 50w to 150w
Exo Terra Repto Glo 5.0 Compact 13w & 26w
Exo Terra Repto Glo 10.0 Compact 13w & 26w
Exo Terra Heat Glo Infra Red Lamp 50w to 150w
Exo Terra Ceramic Heat Emitter Heat Wave Lamp 40w to 250w
SAFETY
All the above should be used with the appropriate thermostat.
Use a heat guard with any heat source.
John
